Pump power is limited to a pre-set value. On some rare occasions, it might get changed. To restore the value, we need to send a direct command to the unit. 

Note about the command

  • Commands are case-sensitive
  • All "0"s are zeros

Steps


1. Go to the Direct command section of the SmartTerra application. Instructions below:

https://chalardus.freshdesk.com/en/support/solutions/articles/48001181114-how-to-send-a-direct-command-to-the-unit


2. Under the direct command input type in the following command to restore the value

r07bPY2000


3. Restart the SmartTerra unit once you are done


Command Syntax explained

r07bPYnnnn (nnnn = direct power from 0 - 8191)